Notícias

An ATS short-circuit rating cannot be judged from the switch ampere rating alone. This matters especially for compact automatic transfer switches used in distribution boards, generator backup systems and OEM...

Generator ATS Commissioning Guide Automatic transfer switch (ATS) time delay settings affect when a utility problem becomes a real transfer event, when a generator-start sequence begins, when the load can...

For a three-phase automatic transfer switch, choosing the pole configuration is not only a mechanical decision. The real engineering question is whether the load neutral should remain continuously connected or...

PC Class vs CB Class ATS is mainly a question of short-circuit protection architecture. Both can transfer a load between two power sources, but they assign fault interruption differently. For...

Choosing between a contactor type ATS and a switch type ATS is not simply a question of which design is faster, carries more current, or costs less. Both architectures are...

B2B Power Switching Selection Guide An automatic transfer switch (ATS), a changeover switch, and an isolator may all appear in low-voltage panels, but they do not solve the same engineering...

When a compact automatic transfer switch is installed in a distribution panel, one of the most important questions is not simply which ATS current rating to choose. The panel designer...

Dual-Source ATS Selection for B2B Projects A dual power automatic transfer switch transfers a load between two alternative power sources. But “dual power” alone is not enough to specify the...

ATS Cabinet Design for Panel Builders Designing an ATS cabinet around a compact integrated automatic transfer switch is mainly an integration task: the panel builder must provide correct source and...